AMZ St Croix Fuchsia 63MLXF ...and components.

My avid Ultra-light weight fisherman friend wants a St Croix 3S63MLXF but unfortunately it was out of stock and he had "little" ( cannot say NO ) choice but to pick the the Fuchsia series.

This metallic purplish pinkish blank have a moderate soft tip and a stiff mid section. I would term this as "tip flex" action.

Amz wanted a comfortable handle for this rod and I proposed the American Tackle "AERO" reel seat.
He gave the the dimension of the handle and I drew a sketch how the handle will look like...

Entire handle.

Fore grip and reel seat.

Fighting butt

Measurements are then mark on the blank.

This is a mock up of the handle. It may or may not turn out exactly the same when finished. But the variance would be at a minimal.

To spice this rod more... I have added a few Matagi components to this rod.

The butt cap and the female screw, just in case a balancer piece is required.

Aluminum trim piece above the reel seat for the fore grip.

And winding checks ...

Everything is completed..... next is to assemble.

KANGeNiZeR MHX SJ720

Completed this casting rod from a spin-jig MHX blank last month and it was sent to my friend in Kelantan.
Simple built-up with PacBay micro guides, Fuji reel seat and cork split grip.

Wanting the rod to look something like the G.Loomis NXR rod, I used sky blue color thread for the wrapping.

All single foot guides for this casting rod.

Static load testing were done to check the bending moment and the guides placement.

The completed rod with cork split grip.

And this was the 1st catch on this rod....

Finishing off my UL bamboo casting rod

This project was shelfed up on September 2011, I think it's time to complete it and put to test.

Following the style of my fly rods, I am giving it a transparent look on the guide wrapping.

Wrapped with Pearsall's Gossamer silk thread.

The wrappings are very visible before the application of the epoxy.

The effect of the wrapping after the 1st layer of epoxy. The guide foot can be clearly seen.

And, did I mentioned that I did a spiral guide placement for this rod.???
YUP....  I made this rod with a spiral guide placement. The ferrule joint of this rod is firm and tight , I should not have any problem of rod twisting during loading.

Next..............  to test this out....

ZUL Barracast Refurbishment

After 6 months of rebuilding the handle of this spinning rod, we are going to convert it to a casting rod...


It was good that my friend have the time to do the stripping of the entire rod.... well almost the entire rod.
He have abit of left over of the reel seat for me to remove.

I have to use the hot air gun to soften the epoxy in the reel seat to have it removed.

The balance of the metallic silver paint and the reel seat removed.

Fitting of new ACS reel seat and aluminum winding check.

Shaped EVA split grip

Since the rod does not have fore grip, a feather inlay above the winding check will stand out on this black colored blank.

Simple black wrapping with metallic red thread trimming on Fuji SiC guides.

A view from the reel seat.

And this rod is finished off with a MATAGI butt cap.